The Manitowoc 999 assisted with both removing precast concrete panels as well as picking and setting replacement tilt wall sections.

Choosing a crane for a construction project is usually a matter of finding the right tool for the job. This is especially true for a job site that needs one crane to perform multiple functions.

A warehouse rehabilitation project in Franklin, Ind., showcased the capabilities of the Manitowoc 999 Series 3 lattice boom crawler crane. The stout crane assisted with both removing precast concrete panels as well as picking and setting replacement tilt wall sections.

The Manitowoc 999 was supplied by Central Rent-A-Crane, a member of the ALL Family of Companies. It has a 275-ton capacity and was configured with 130 ft. of main boom and full counterweights. For its capacity range, it offers a combination of high performance, easy mobilization and versatility, including a small footprint combined with high capacity, fast self-assembly, and 290 ft. of reach.

The new concrete tilt wall was poured on site using molds on the ground. Once the wall cured, the crane was used to pick a concrete section off the ground and position it on the warehouse structure, holding it in place while it was secured by a team of technicians. Each panel was approximately 40 ft. long and 8 to 10 ft. wide.

Every lift required meticulous planning and careful execution due to the limits on how much bowing the poured sections would tolerate as they go from horizontal to vertical. By running both lines on the Manitowoc 999, the operator could connect at two points to pick the panel and stand it up with minimal pressure on the panel structure.

"It takes finesse," said Tim Welty, sales representative of Central Rent-A-Crane. "You can't simply run a single line to the end of a panel and hoist up. It would put too much pressure on the mid-point of the panel."

Pre-lift calculations and 3D modeling gave proof that the recommended solution would succeed.

Once positioned, the team on the ground braced each piece with adjustable bars to temporarily secure the panel until it could be permanently secured. Metal expanses poured inside each piece of tilt wall are welded together to form a permanent bond.

The crane was positioned between the warehouse and the pour line for the new panels. From this position, it could pick cured panels and swing to the destination. The same crane also was used to pull old precast panels from the warehouse to create room for the replacements.

"The Triple 9 is a versatile tool for Central to have in our fleet," said Welty. "Its combination of size, power, and reach was perfect for this job, wherein, without it, our customer may have needed multiple cranes to achieve the same end."

About ALL

The ALL Family of Companies is the largest privately held crane rental and sales operation in North America, operating under the ALL, ALT, Central, Dawes and Jeffers names. For more information, call 800/232-4100 or visit www.allcrane.com.

This story also appears on Crane Equipment Guide.

Today's top stories

Georgia Is Moving Ahead to Enhance Highway Networks

Iowa DOT's I-35 Project Includes New Bridges

Year in Review: Bobcat's Major Moments of 2024

Hiring, Retaining Construction Employees Starts With Attracting Right Candidates

MassDOT to Use Drones for Infrastructure Projects; Amherst Exploring New Downtown Designs

Eight I-15 Bridges Open in Idaho, Project Still Ongoing

DEVELON Set to Exhibit at ARA Show 2025

JM Wood Holds December Auction in Montgomery, Alabama